Hello, Does anyone have recommendations on swapping out the bilge pump on a 2007 Sportsman 220? Brand? Where to buy it? I work on my cars a little bit and I do the maintenance on my outboard, but I've never swapped out a bilge pump. I have not done my research yet, but I assume it's located in the stern in a really inconvenient location. Does anyone have a diagram of where the bilge pump is on a 2007 Sportsman 220? It's not near my fuel/water separator, and that's as far back in the boat as I can get. Do I have to remove my fishboxes to get to the bilge pump? For some reason, I have not been able to locate it.
Has anyone replaced their drain plug? I see GreatLakesSkipper listed as a good parts supplier, but I'm wondering where others shop?
Has anyone purchased/installed a taller stalk for the captain's seat. I generally sit on a pile of life jackets so I can see over the windshield.
Has anyone purchased new cushions/replacement cushions, especially for the lounger seat? What about fishbox hatches? I've done some fiberglass and gelcoat repairs on other parts of my boat, but I'd like to buy new fishbox hatches, and maybe replace the storage compartment hatch.
Regarding the lounger seat, the locking handles/adjustment handles broke off. From what I can tell, it's the equivalent of a 1/4-inch screw thread on T-handle. Where did you buy replacement handles?
Thanks in advance.

Hello, When I drive my boat, my gauges will often lose power, then pop back on. It all depends on the bumps I hit on the water. I assume i have a lose ground wire somewhere. If anyone has some solutions, I would appreciate it. Does anyone have a wiring diagram for a 2007 Sportsman 220? Thanks in advance.

Hello,

My name is Chuck & I live in Las Vegas, NV. I am the new proud owner of a 1992 Wellcraft 3300 St. Tropez with dual Mercruiser 454 7.4L engines. My Wellcraft is parked in Redondo Beach, CA. Although my St Tropez runs it is in need of a fair amount of restoration which I am starting in on this weekend & I look forward to the challenge.

Hi,I just bought a Martinique 3600 Year 1998 in Thailand. Please help me to find the owner manual ? Thanks in advance!

have a 1997 wellcraft 190ccf center console. It has a sump area where the bilge pump lives. It's sealed with epoxy substance but I noticed water enters from the left side of the sump depression. Looks like its by design unless someone says otherwise. Not sure if that's intentional or if i should close off that area with some 4200 fast cure? Thanks

I have a 1997 Scarab 31 Excel w/tin 502' blown (94 on GPS .... Great fun). I left the finger lakes region of NY, am currently residing in Belize, CA but looking on Smith Lake, AL for new digs. Boat needs some attention, and looking for guidance. The engine air intake guards are broken, and need replacing. Also the access panel to the fuel tank is getting 'spongy'. Is there a parts manual with diagrams so I can properly refer to the parts?
Thanks all for being here and giving support.

I have a 1983 Wellcraft Scarab 377 with 370HP 454's, the drives are missing and I need to know what outdrives were on it originally. Any help out there?
Thx
Steve

I have a 2000 Martinique 3700 with twin 8.1 454 Horizon S engines. I just bought the boat less than a year ago and feel the props are under sized, it currently has 17 x 17 three blade on it. If you have any info on what the correct props should be that would be great. I have a hard time getting on plane when it does it just throws a excessive amount of water out the back. My speeds seem to be slow as well about 18k on cruise and 23k top end. Thanks for any and all help in advance.

My Gran Sport 1989 for sale. Transferable slip. SW Florida area. Nice and clean with new canopy, and a/c unit and more all been done. A very motivated seller $15,000 as is. All working and seaworthy.

I need a ECM for my crusader engine on my 1989 gran sport. Where can I find one or get a used one or a refurbished one? Really having difficulty locating one! Thanks guys.