Page 1 of 1

Wiring schematics Wellcraft 2600 Martinique 2003

Posted: Mon Aug 11, 2014 4:09 am
by Ahlquist
Hi,

as the subject says I'm looking for Wiring schematics for my boat. Does anyone know where I can find it? I have looked at Wellcraft.com with no luck...

Thanks,
Christian

Re: Wiring schematics Wellcraft 2600 Martinique 2003

Posted: Wed Aug 13, 2014 10:37 pm
by goodday
I have a 2600, as for the mercruiser I have a stern drive repair manual from Seloc, it has all your engine wiring schematics,, I see my boat wiring has small # tags at switches,fuses and at item that is running through rest of boat, do you have some prob?

Re: Wiring schematics Wellcraft 2600 Martinique 2003

Posted: Sun Aug 17, 2014 6:41 am
by Ahlquist
Hi, thanks for answering! I don't know if it makes any difference for the wiring but I have a Volvo Penta 5.7 GI.. Previous owners has added equipment and changed some parts so the wiring is not easy to follow. For example I would like to have only the starter on one battery and the rest on the other 2 two "consumption" batteries, to be sure to always be able to start even if the other two batteries run empty during a night, but this is not the case now. On most of the wiring there are tags with number so a list of which wire goes to what would be helpful?
Thanks!

Re: Wiring schematics Wellcraft 2600 Martinique 2003

Posted: Sun Aug 17, 2014 12:07 pm
by railroad124
I just added Blue Sea Add A-Battery and its been a great addition.

Re: Wiring schematics Wellcraft 2600 Martinique 2003

Posted: Sun Aug 17, 2014 9:35 pm
by goodday
I have a select switch, when im in a slip without power on an overniter, I slip it to just one batt. So one is not ran down, but I dont use that much batt. If not running refig., you should have a select switch in bilge. Your autobilge should be wired direct even if your batt. Are on shut off. Good luck

Re: Wiring schematics Wellcraft 2600 Martinique 2003

Posted: Mon Aug 18, 2014 3:30 pm
by Ahlquist
I have the same switches but at the moment fridge and some other stuf is on the same battery as the starter so I have a nice winter job to do and was therefore looking for wiring schematics to track which wire goes to what...

Re: Wiring schematics Wellcraft 2600 Martinique 2003

Posted: Sun Apr 12, 2015 6:33 pm
by Joethemaddog
On my boat all of the equip is hooked up to the six batteries currently installed I replaced the wiring by moving one and installing it's replacement one at a time. Now I am thinking of ripping it all out and starting from scratch and separating the load into three seperate batteries as follows engine and its accessories, electronics house load (refrigerator lights etc) I am having difficulties locating a. Diagra for the wiring So thought this might be my best option

Re: Wiring schematics Wellcraft 2600 Martinique 2003

Posted: Sun May 10, 2015 10:35 pm
by goodday
Joethemaddog,Where do you have 6 batt. at?. seems like a lot of extra weight for 21 ft., seems like 2 would be enough, maybe get a batt. switch to switch batt. back and forth to keep a charge on one or the other or both when running. then just use 1 batt. at a time if your not running . batt. switch instructions will give you batt hook up dia.