Counter sinking screw holes as a repair?
Posted: Tue May 17, 2022 10:11 am
Good morning folks,
As I take stuff off of the hull that is outdated, there are several screw holes that need to be covered.
at least a few will be under the water line.
My thoughts are to counter sink the hole in order to put a screw with 4200 back in it's place. Hopefully leaving a flush surface.
thoughts on this, or other simple fixes to the holes?
As I take stuff off of the hull that is outdated, there are several screw holes that need to be covered.
at least a few will be under the water line.
My thoughts are to counter sink the hole in order to put a screw with 4200 back in it's place. Hopefully leaving a flush surface.
thoughts on this, or other simple fixes to the holes?