Wellcraft Boat Owners Forum

Does anyone know the shaft clearance on a 2003 Martinique 330? I'm trying to determine the maximum size prop possible for this hull design with factory running gear. For reference, the shaft clearance is measured from the centerline of the shaft to the hull at a 90deg angle from the centerline, and measured at the midpoint of the taper. The customer would measure it herself, but the vessel is in the water and very far away.

Any prop selection experience with this vessel would also be welcome. Her boat is equipped with 8.1 375hp gas engines and 1.99:1 reduction gears.

Thank you.