I have a 2000, 24' Walkaround. I am getting getting wet carpet in the cuddy. The rear bilge is dry, I can only assume the forward bilge is holding water, but I do not know how or if there is a forward access to it. Could it be below the plate that supports the table?

Hi, if you or anyone you know that has a Nova XL 1989 that is parting out i need some parts. Let me know here if you could. Thanks, Dan

So, I bought a Brother LB 6800 and have been doing my interior. Just thought I would share some pictures. Enjoy
Dan

Hey, my indash. lighted compass froze and broke last winter. I have a 1989 Nova 230 XL and need a stock compass for that year and make. Other yrs. and make boats by wellcraft may work just not sure which ones?

Hi, I have a 1989 Nova 230 XL with a 350 Mag stock with thru hull exhaust w/ captains Call. I am looking for a customer used riser for smoother exhaust. must match original position on exit as I already have through hull exhaust. Thanks,

Hi WellCraft Baot Lovers!, my name is Dan and I have a 89 nova 230 XL. Glad to be part of this forum as there is always good info to research and find. Thanks for letting me join! Glad to be here!
Dan

Hello not sure the length of throttle cable for a 33 foot Martinique, 2000 wellcraft. Plus recommend site to purchase from.

Hi Guys:

Anyone who have installs a Westerbeke 5Kw to replace existing Kohler 5kw? I had a lot of problems with Kohler 5ECD, and the newer version the width is about 1" wide than 5ECD, I looked the Westerbeke 5Kw which is .5" wider than the 5ECD and runs 1,800 rpms, less louder than Kohler. My Only concern with the Generator is the Weight that is 330#. Your comments will be welcome.

Jorge

Hello everyone!
I am new to this site as of today. I have recently purchased a wellcraft sportsman 250 boat. I went to restore a few items on it and when I removed my switch panel on the dash all of the wires were corroded and broken, but some how everything was running properly until I removed the panel. must have been the slight movement that broke the wires. The fuse panel just pretty much fell apart, so now I have no idea where anything goes. I have purchased a new fuse panel, but I now have no idea what wires are for what. I have searched high and low and have even called around and I have had no luck what so ever. If anyone could help it would greatly be appreciated!! I don't even want to think of the idea of having to trace each and every last wire.

Thanks in advance.

Has anyone replaced these? It's a 2007 290 coastal.